By far the largest proportion of the production in ANNON is made according to customer specification. The
range include all normal geometries |
| Discs Plates Rings Tubes Half-discs Focussing Bowls Hemispheres |
For special requirements, please contact ANNON Piezoceramics A/S directly |
Discs are offered in a standard programme, or can be produced to a specific size, frequency, or with a specific electrode pattern. All standard compositions are available.
Diameter range is OD 2 mm to 120 mm.
Thickness range is 0,05 mm to 25 mm. |
Plates are offered in a standard programme, or can be produced to a specific size, frequency, or with a specific electrode pattern. All standard compositions are available.
Length range available is 3mm to 176 mm.
Width range available is 1mm to 120mm
Thickness range 0,05 mm to 30mm.
|
Rings are offered in a standard programme, or can be produced to a specific size, frequency, or with a specific electrode pattern. All standard compositions are available.
Diameter range is OD 4 mm to 120 mm.
Thickness range is 0,2 mm to 25 mm. |
Tubes are offered in a standard programme, or can be produced to a specific size in all standard compositions.
Diameter range is OD 4 mm to 90 mm.
Length range is 1 mm to 30 mm.
|
Half-Discs can be produced to a specific size, frequency, or with a specific electrode pattern. All standard compositions are available.
Diameter range is OD 2 mm to 90 mm.
Thickness range is 0,05 mm to 25 mm. |
Focusing bowls are available in all standard compositions. Special non-standard diameters, resonant frequencies, focal lengths (R1) and closer tolerances can be made on request.
Diameter range is OD 2 mm to 65 mm
Resonant frequency range available: 100 kHz to 15 MHz
|
Hemispheres are available in PZT-5A and PZT-4. All parts are made according to customer specification. The parts are grided from a solid block, thus securing the best possible tolerances and a uniform sensitivity from all parts of the hemisphere.
Diameter range is OD 5 mm to approx OD 50 mm.
Wall thickness range is from 0,2 mm |
PLEASE NOTE: There will typically be a tooling cost for initial orders |
|